TITEBOND COLD PRESS HPL


Titebond Cold Press for HPL is a high-quality, economical alternative to contact cement for large-scale flat laminating. It is specifically formulated for cold press laminating of High Pressure Laminates and backed veneers to solid woods, particleboard, MDF, plywood and other porous materials. Titebond Cold Press is also suitable fo...

more

Features & Benefits

check_circle
Moderate speed of set
check_circle
Economical alternative to contact cement
check_circle
Dries translucent
check_circle
Water cleanup
check_circle
Suitable for large-scale flat laminating
check_circle
Suitable for panel-on-frame cold press applications

Application Guidelines

Application Temperature:
Above 50°F (10°C)
Open Assembly Time:
15 minutes (70°F./50% RH)
Total Assembly Time:
15-20 minutes (70°F./50%RH)
Minimum Required Spread :
Approximately 6 mils or 250 square feet per gallon
Required Pressure Application :
30-80 psi for HPL, 100-150 psi for Panel-on-Frame, 100-250 psi for Veneer
Method of Application:
For most consistent coverage a mechanical spreader is recommended.
Cleanup:
Damp cloth while glue is wet. Scrape off and sand dried excess.
Limitations:
Titebond Cold Press for HPL is specifically designed for laminating flexible materials and is not suited for other types of assembly applications. Vacuum pressing should only be used for veneers up to 1/16 inch in thickness. Do not use when temperature, glue or materials are below 50°F. Not recommended for exterior use or where moisture is likely. Freezing may not affect the function of the product but may cause it to thicken. Agitation should restore product to original form. Read MSDS before use. NOTE: STIR PRODUCT BEFORE USE TO ENSURE UNIFORMITY. KEEP FROM FREEZING.

Physical Properties

Type
Modified PVA emulsion
Calculated VOC
3.2 g/L
State
Liquid
Weight Per Gallon
9.7 lbs.
Color
Off White
Dried Film
Translucent
Flashpoint
> 200°F
Solids
42%
Freeze / Thaw Stability
Stable
Viscosity
4,500 cps
pH
4.9
Chalk Temperature
To assure a good bond, 50°F is the lowest recommended temperature of the glue, air and materials during application.
Storage Life
12 months in tightly closed containers at 70°F

Bond Strength ASTM D-905 (On Hard Maple)

Temperature Strength Wood Failure
Room Temperature 2,711 psi 32%
150°F. Overnight 1,890 psi 1%

Caution Statement

CAUTION: EYE AND SKIN IRRITANT. Contains oxydipropyl dibenzoate. Don not swallow. Do not allow eye contact or prolonged skin contact. FIRST AID: if swallowed, do not induce vomiting; contact physician. If eye contact occurs, flush eyes with water for 15 minutes. Wash skin contact areas with soap and water. If irritation from eye or skin contact persists, contact physician. For additional information, refer to Safety Data Sheet. KEEP OUT OF THE REACH OF CHILDREN.