Refer to the flooring manufacturer’s specific recommendations for suitable substrates. Porous: Concrete, well-bonded cementitious underlayments, APA grade underlayment plywood (untreated) and radiant-heated subfloors where temperatures do not exceed 85°F (29.4°C) on all grade levels. Also can be used over well-bonded, properly primed gypsum underlayments (above-grade only). Non-porous: Ceramic tile, terrazzo, marble, certain epoxy coatings and existing well-bonded resilient flooring (not perimeter bonded or cushion-backed). Please note that all substrates must be sound, solid and well-bonded.
All substrates must be clean, dry, structurally sound, properly cured and free of dirt, oil, paint, old adhesive, wax, sealers and curing agents. General scouring with 20 grit or #3 1/2 open-coat sandpaper will remove most compounds. All loose materials must be vacuumed from the surface after scouring. The subfloor must be flat to a tolerance of 3/16” in a 10’ radius. Grinding concrete floors is preferred over the use of filling compounds. If filling/flattening compounds are used, they must be Portland-based cementitious material and have a compressive strength equal to or greater than 3000 psi when cured. Moisture level in concrete subfloor will fluctuate. Any cementitious material used must be rated for the highest moisture content possible. Consult the cementitious material manufacturer’s application directions. Use of adhesive over lightweight concrete and all gypsum-based materials requires the use of an approved concrete primer prior to application of adhesive.
Floor Covering Recommendations
Titebond 720 is designed for carpet with polypropylene woven, woven, unitary, jute, latex unitary, foam, sponge, polyurethane, hot melt, rubber backings, latex, soft backed unitary. It also works on tile including: cork tile, rubber tile, pure vinyl tile. Sheet Goods: felt, paper, rubber backings. It may also be used with sheet goods with mineral, felt, paper or rubber backings.
CARPET DIRECTIONS: Lay carpet into wet adhesive within 15 minutes after adhesive application, in order to ensure adhesive transfers to backing. In the case of sealed surfaces, it may be required to allow adhesive enough open time to become tacky to the touch before laying the carpet. After installation is complete, roll carpet with a lightweight roller or a carpet tube.
SHEET GOODS: Lay sheet goods into wet adhesive within 10 minutes after adhesive application. Lift corner periodically to determine if adhesive is transferring to goods backing. Immediately after installation, roll the floor with a linoleum roller, working from center towards edges to expel entrapped air. For “hard to hold” curled goods, allow adhesive to tack up to the touch before laying goods in order to promote quick adhesion.
Allow adhesive to dry well before exposing installations to cleaning water. Use water to remove adhesive spots and clean tools.
Do not sand, scour or abrade any material that is suspected of containing asbestos fibers. Asbestos is known to cause cancer. Federal law requires that asbestos be handled by a licensed and certified hazardous materials contractor.